Promitheus Audio Solid State DAC

The main board for the DAC.

Our Non-oversampling DAC using the TDA1545A chip with Asynchronous Relocking, Passive I/V stage. Output transformer coupled

Features
 

• Our own  silver pulse transformer (this separates the ground thus resulting in a quieter music) to couple the digital output of your cdp into our DAC. Our nickel core transformer is wound on a 2mils lamination (0.05mm).

•  Therefore the digital ground is broken up between the DAC and the Transport/CDP to allow a cleaner presentation as the grounds are isolated

• Dedicated pre and post regulator (for each chip) to bring down the noise floor

• Specially wound Balanced power transformer to power DAC, this is the same winding topology as our balanced power supply. This further brings down the noise floor. The power transformer is wound on a M6 core

• Dedicated windings on the power transformer for the digital power supply and the analog power supply. This is NOT shared to prevent the transfer of digital noise to your precious analog power supply.

• The power transformer is fitted with MULTIPLE electrostatic shields to prevent the spreading of the noise cause by digital circuits. This electrostatic shields shunt noise to ground thus keeping the power supply clean

• Asynchrous reclocking to 100Mhz. Clock module is place below the PCB to prevent spraying the board with noise. The clock module is located at the bottom left end of the PCB. The clock has its own dedicate power supply to decouple the noise generated from the clock

• The DAC is design around a good power supply system
  • IN the digital segment there is a master regulator and then its is fed into local regulators individually finding the IC. SO each digital IC is totally isolated from another digital IC
  • The Opamp segment is run again with its own local discrete regulator. This keeps the noise isolated between left and right op-amps

• Selectable gain structure of 1.25volts out, 2.2volts out and 4 volts output. This allows user to optimize their gain structure.
• On the output, output transformers is used to couple the analog voltage from the DAC to the outside world. This way the DAC is impedance match to your down line equipment. This output transformer is wound on a M6 core
• Chassis for the DAC is built on our tune wooden Merbau wood with Stainless Steel plate similar to our TVC construction
• Our new Neotech 7N copper for internal wiring Teflon wires for power
• Pure Silver RCA used for digital input and analog output
• USB input and Coaxial Input

 Check out our Audiocircles postings on our DAC

The DAC review in

The awards DAC has won

 For a limited time we are selling the DAC for USD490 + shipping.  

DHL shipping to United States, Japan, Asia, Australia USD80

Rest of European Union countries USD128

Custom Modifications for the DAC

Purchase our Power cord together when buying our DAC

USD150 when purchased with our DAC or Active Preamp

The DAC weights 5.5kgs due to the oversize power transformers and the output transformers

If you need more inputs, outputs do not hesitate to email us.

Back to Main page